- Shop
- HD Combo Stand
- Trainer Packs
- AR500 Hook Mount Steel Targets
- Angled Targets
- Precision Rifle Targets
- AR500 Steel Gongs
- Sihouette AR500 Steel Targets
- Reactive Targets
- Target Stands
- Steel Challenge
- Moving Targets
- 22 LR Rimfire
- All AR500 Steel Targets
- AR500 Knock Over Targets
- AR500 Steel Target Accessories
- HD Combo Stand
- Shop
- HD Combo Stand
- Trainer Packs
- AR500 Hook Mount Steel Targets
- Angled Targets
- Precision Rifle Targets
- AR500 Steel Gongs
- Sihouette AR500 Steel Targets
- Reactive Targets
- Target Stands
- Steel Challenge
- Moving Targets
- 22 LR Rimfire
- All AR500 Steel Targets
- AR500 Knock Over Targets
- AR500 Steel Target Accessories
- HD Combo Stand
2 HD Popper Stands
$96.00 – $116.00
Wishlist Please, enable Built-in Wishlist.Our Popper stand is built to last!
Perfect for competition, range or private use!
This listing includes 2 stands!
These stands are fabricated with 1/4″ steel plate stand.
The stand has a wide footprint to make it very stable – so stable you don’t need stakes, although it is drilled for them.
Popper stand also includes a calibration bolt in the upright, so you can adjust the amount of force it takes to knock over the Popper.
The set includes 2- 12″x12″x 4 1/4″ 1/4″ steel stands
Order yours today for some shooting fun!
| Finish | Painted, Unpainted |
|---|
1 review for 2 HD Popper Stands
WE WANT YOU TO BE SAFE!
When using steel targets safe shooting distances are as follows: Handguns — 15 yards or greater; Rifles — 100 yards or greater. Steel targets should never be shot with a 50 BMG or steel core bullets. Any bullet with steel in jacket could dimple AR500 when shot at close range. If bullet projectile is magnetic it contains steel. BB, pellet and airsoft guns should not be used. They will bounce back.
Superior Ideas, Inc. assumes no responsibility or liability whatsoever for the use or misuse of targets. You are agreeing to these terms as a buyer.
MADE IN THE USA
We're proud to be an American company.
SHIPPING ONLY $15 PER ORDER!
Order more and save on shipping.
Christopher A. “Norm” Stallworth (verified owner) –
A pair were purchased after a few of the club’s Colt Speed Steel plate stands needed repair. Rather than have the stands get welded, I tried these plates to facilitate a 2 piece plate/popper option.
These plates have so far worked out exceptionally well. Their foot print is wide which helps to keep the targets a bit more stable on damp or muddy ground.
Though the plates are heavy duty, a two piece popper configuration makes it easier to lift, carry, setup and to store.
I prefer these over a simpler L-Shaped stand since they have more surface area and an angled strike plate area to protect the calibration bolt.